Gallery, Projects and General > Gallery
Gingery Lathe and Accessories
vtsteam:
And here is the finished fly cutter mounted on an arbor between lathe centers, doing what it is supposed to do -- milling a surface on the new boring table casting.
vtsteam:
Also milling the side of the table. At this point, I'd decided to add removable bolt-on wings to the sides of the table -- these would be L shaped and take bolts for clamping flat pieces down on the table. Also some bolt on cross pieces that could be used similarly. Anyway, I needed the sides to be square and milled to accept the add-ons. The fly cutter worked well for this, too.
vtsteam:
Cutting the side. I had to relieve the lathe tool for a long way to give it clearance, and make separate tools for each side, but it worked!
vtsteam:
Patterns for table add-on pieces, and another smaller fly cutter.
vtsteam:
Ramming up.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version