Gallery, Projects and General > Gallery

Gingery Lathe and Accessories

<< < (4/24) > >>

terryd15:
Hi VT,

Keep the reports coming, it's a very interesting project,

Best regards

Terry

Stilldrillin:
Hi VT.
What stories you tell. Of wonderful, successful projects!  :bugeye:  :clap:  :clap:

Please keep 'em coming. I'm thoroughly enjoying your progress.  :thumbup:

David D

PekkaNF:
Great story and very inspirational too! Keep it coming. I enjoy very much reading this.

Pekka

tom osselton:
I find this quite interesting and always pickup some useful information on most builds. I haven't made a furnace yet but it is in the near future. I have read some casting books and some on pattern making but haven't seen that trick with the soot used before how much force does it take to drive out the steel rod after? Do you drive it out cold or do you expand the casting with a little heat? I was thinking that it could be posible to use this method to line up the main bearings during casting.

Fredbare:
Thanks VT for sharing, wonderful work. I have just built a furnace, you certainly have inspired me, keep em coming.

John

Navigation

[0] Message Index

[#] Next page

[*] Previous page