| The Shop > Our Shop |
| Building my new workshop |
| << < (19/19) |
| mechman48:
Hi Tim Looks super :clap:; not into cnc mesel' :scratch: bit long in the tooth for it nowadays, still getting used to manual DRO's, not that I've done a lot lately, just seem to end up titivating this & that all the time :dremel: George. |
| spuddevans:
Thanks guys :thumbup: --- Quote from: mechman48 on June 23, 2013, 12:14:37 PM ---Hi Tim Looks super :clap:; not into cnc mesel' :scratch: bit long in the tooth for it nowadays, still getting used to manual DRO's, not that I've done a lot lately, just seem to end up titivating this & that all the time :dremel: George. --- End quote --- Actually, I mostly use it (the CNC) in a manual mode, using the DRO functions on Mach3. I think I've only ran about 4 or 5 true CNC programs. Most of the time I just manually enter the Co-ords of where I want it to go, and the feed rate. Sort of "Single Step CNC" I guess. I got a little more done, mainly tidying up. But I also trammed the mill, and put up another shelf for Lathe/mill acc's and hung some toolholders on the wall. I also discovered that one of the Stepper Motor Drivers is faulty, fortunately it is the Rotab driver, so not used so much. Got another one coming. Tim |
| spuddevans:
Got the Vinyl flooring down, looks a lot better and much easier to sweep. As you can see I also have got another offcut to put in front of the Lathe and Mill, hopefully to catch most of the hot swarf before it damages the main flooring. :thumbup: I also installed a few handles on the doors of the Mill/Lathe bench. Keep tuned for irregular updates, Tim |
| Stilldrillin:
Mrs. Drillin wants to know, if you could do something similar with her kitchen? :lol: Looking good Tim! :thumbup: David D |
| Navigation |
| Message Index |
| Previous page |