The Shop > Our Shop
Building my new workshop
spuddevans:
You guys are not far from the truth, I do dabble a little in the kitchen, I make the best Brownies this side of the river Bann :lol:
The workshop has a better oven and much better cabinets than our present kitchen, my wife is quite jealous.
I figure that the hob can be useful for heating Alum solutions when dissolving taps, and the oven could be very useful when/if I get a powder coating system, plus for when making shrink-fits.
And the sink is needed to fill the big hole in the worktop (but I probably will plumb it in too, be useful for scraping the crud off the hands before returning to the house)
On the plus side, I've got a bit of space back now
Tim
DavidA:
Suddenly the whole place looks a lot smaller. Where are you going to put your milling machine ?
Dave
DMIOM:
--- Quote from: DavidA on May 01, 2013, 07:16:51 PM ---..... Where are you going to put your milling machine ? .....
--- End quote ---
Is that the Pepper Mill you're referring to ?! :dremel:
Dave M
spuddevans:
--- Quote from: DavidA on May 01, 2013, 07:16:51 PM ---Suddenly the whole place looks a lot smaller. Where are you going to put your milling machine ?
--- End quote ---
I've got to build a bench for it and the mill, it will go against the wall on the right of those pictures :thumbup:
Tim
mechman48:
Where are you going to put your fridge. in the empty space at the end on the left hand side of your pics? :lol: by the way where did you get all that good stuff was it from a reclaimed kitchen or did you purposely buy it? no wonder the wife is jealous :drool: looking good anyway.
George
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version