Building my new workshop

The Shop > Our Shop

<< < (14/19) > >>

spuddevans:
You guys are not far from the truth, I do dabble a little in the kitchen, I make the best Brownies this side of the river Bann :lol:

The workshop has a better oven and much better cabinets than our present kitchen, my wife is quite jealous.

I figure that the hob can be useful for heating Alum solutions when dissolving taps, and the oven could be very useful when/if I get a powder coating system, plus for when making shrink-fits.

And the sink is needed to fill the big hole in the worktop (but I probably will plumb it in too, be useful for scraping the crud off the hands before returning to the house)

On the plus side, I've got a bit of space back now

Tim

DavidA:
Suddenly the whole place looks a lot smaller. Where are you going to put your milling machine ?

Dave

DMIOM:

--- Quote from: DavidA on May 01, 2013, 07:16:51 PM ---..... Where are you going to put your milling machine ? .....
--- End quote ---

Is that the Pepper Mill you're referring to ?! :dremel:

Dave M

spuddevans:

--- Quote from: DavidA on May 01, 2013, 07:16:51 PM ---Suddenly the whole place looks a lot smaller. Where are you going to put your milling machine ?

--- End quote ---

I've got to build a bench for it and the mill, it will go against the wall on the right of those pictures :thumbup:

Tim

mechman48:
Where are you going to put your fridge. in the empty space at the end on the left hand side of your pics? :lol: by the way where did you get all that good stuff was it from a reclaimed kitchen or did you purposely buy it? no wonder the wife is jealous :drool: looking good anyway.

George

Navigation

 Message Index

Go to full version