| The Shop > Tools |
| Chester Mini Mill. |
| << < (2/7) > >> |
| Stilldrillin:
--- Quote from: Darren on February 27, 2009, 08:49:03 AM ---New sofa, carpet, bedding, curtains, cooker, heck the whole kitchen inc the flooring it is then...... :clap: "WE" can be a very expensive word :lol: --- End quote --- No problem....... We can afford it! :thumbup: Found a few usefull artifacts this afternoon...... :clap: Almost brand new finger clock. Magnetic base. Wobbler. 10 or so assorted cutters. 6 off 10mm "oversize" (compared to supplied) T nuts. That will do nicely..... :thumbup: David. |
| malcolmt:
David Nice Find Where did you Find Them Malc |
| sbwhart:
Nice find David Those DTI are a real good addition to any ones tool box got a 1000 and 1 uses, you'r realy cooking on gas now :ddb: Have fun :wave: Stew |
| Stilldrillin:
--- Quote from: malcolmt on February 27, 2009, 06:53:26 PM ---Where did you Find Them Malc --- End quote --- Malc, It`s just amazing what follows you home, during a whole engineering career. ::) I`m sure several little surprises are still waiting to be discovered in long forgotten corners & boxes. :clap: The T nuts were a complete, happy surprise! :thumbup: I only recall using 5/8 Whit, or in later years 20 & 24mm....... Stew, Thanks mate....... I am having great fun! :thumbup: David. |
| Stilldrillin:
Finally got the machine stripped. Red gloop everywhere, outside...... Dry, no lube anywhere inside...... ::) Now starting to rebuild, with better fitting & adjustment...... :thumbup: All going well, so far.... David. |
| Navigation |
| Message Index |
| Next page |
| Previous page |