| Gallery, Projects and General > How do I?? |
| screw-cutting basics |
| << < (6/6) |
| Fergus OMore:
Hi Terry, Hoorah for the Brylcream boys! I'm a 31-er. :bow: A point about GHT's little boring head. It was never said but it makes a very nice ball turning fixture if you enable the No2 or iit may be 3MT( for you) to be removed and replaced with a parallel bit of round. I've been swopping some of my Imperious stuff for metropolitan varieties. Regular attendance at Screwfix and Tool y Stations. Drop me a note with your private e-mail add before this old sh1t hawk falls off his perch. Norm |
| minerva:
Hi UDIMET many thanks for your input, sadly at the moment I do not have a PC which uses Windows but hope to have one in the near future. meantime I will attempt to get the programme to run on Linux under Wine kindest regards Terry AKA Minerva |
| minerva:
Hi guys, for the third time I am attempting to post. I have thanks to your input just about finished my VDH build and attach a couple of photos, again many thanks I still have to drill the indexing holes but hopefully shouldn't take too long Regards Terry T shows the basic 24 hole head shows the extended version with my home made collet chuck fitted another view of the basic head |
| Rob.Wilson:
Hi Terry :clap: :clap: :clap: :clap: :clap: That a very well made dividing head :dremel: Rob |
| minerva:
Hey Rob, thanks for your welcome comments. As is possibly evident I still have to manufacture the sector arms (?) and drill the division plates but I have considerable reading to do in order to get my head around the theory before I start drilling. A further complication arises from the simple fact that the VDH is designed primarily with the Myford range in mind so an adapter must be fabricated in order for the head to be compatible with my 920 boring table Tee slots, and of course raise the centre height above the boring table to match the lathe centre. Ah well still plenty to do!! Kindest regards Terry T |
| Navigation |
| Message Index |
| Previous page |