| Gallery, Projects and General > How do I?? |
| machine an eccentric |
| << < (3/3) |
| Jasonb:
--- Quote from: Lew_Merrick_PE on December 29, 2012, 12:24:37 PM ---Otherwise, you stick a 2 mm shim inside one jaw of your 3-jaw chuck, tighten everything down, and walk through all the alignments to make sure that nothing is tipping. If my assumptions (stated above) are correct, this should work for you... --- End quote --- No a 2mm shim will not work as the other two jaws also move, thats why you need Marvs program to calculate the shim thickness. Personally I would do it in the 4 jaw. Mark out and punch the end 2mm off center, clock the punchmark with pump ctr and dti and then turn as required. J |
| Navigation |
| Message Index |
| Previous page |