Gallery, Projects and General > How do I??

<scratch head> Ok so how do I align this properly???

<< < (3/3)

bogstandard:
I see,

Boasting that you've got more brain cells than me   :wack:


Bogs

rleete:
Bogs, ust throwing out an alternate idea.  There's no doubt in my mind that your way is better - after all, if you want something perpendicular to the surface, it's best to use that surface to guage to.  Not sure if I would use the wedge idea, though.  Probably make a bit to fit in the slot tighter and indicate off that.

See, being a CAD guy (the real thing, not just C-o-C), I've kinda gotten used to 'seeing' things in 3D.  But, I've learned that most others don't have that particular skill handicap, so I thought I'd toss that out to get him to look at it another way.  Being the headcase that I am, I decided to model it.  Just being a little off center with the slot can throw the angle off quite a bit.  Of course, it depends on the diameter of the bar, and the width of the slot, but it could be off enough for it to bind if he wasn't careful.

bogstandard:
R,

I just made an offering, as I said before, there are most probably hundreds of different ways the problem could be overcome.

I almost always go for the easiest and cheapest.

Bogs

Navigation

[0] Message Index

[*] Previous page