Gallery, Projects and General > The Design Shop

Help needed with Bantam 800 Feedscrews/Nuts please.

<< < (2/2)

doubleboost:
Hi
Chris
My Bantam was metric
I always found the cross slide feed a bit on the coarse side
Is there no screws and nuts available for it commercially
John

rotorhead:
Hi John,

I'm sure I'll have to make the nut, we've seen a metric one on eBay for £150, stuff that.

Also using 5/8" dia bar will give the correct dia for the spline head, I'll post this original screw pic to see if it's the same.

I'm sure this lathe is Imperial as it has dual dials and there's no metric thread pitched feedscrews.

Chris

Navigation

[0] Message Index

[*] Previous page