| Gallery, Projects and General > The Design Shop |
| Help needed with Bantam 800 Feedscrews/Nuts please. |
| << < (2/2) |
| doubleboost:
Hi Chris My Bantam was metric I always found the cross slide feed a bit on the coarse side Is there no screws and nuts available for it commercially John |
| rotorhead:
Hi John, I'm sure I'll have to make the nut, we've seen a metric one on eBay for £150, stuff that. Also using 5/8" dia bar will give the correct dia for the spline head, I'll post this original screw pic to see if it's the same. I'm sure this lathe is Imperial as it has dual dials and there's no metric thread pitched feedscrews. Chris |
| Navigation |
| Message Index |
| Previous page |