The Shop > Software Tools
emco compact 5 cnc
jb3cx:
Hi all,i have aquired an emco compact 5 cnc with the 6 station toolchanger,does any one else have one of these laths,what i am looking for is the welturn software.i went on to there site but it has closed down,or is there any other software i can use on this machine.the machine works fine as it is by using the keyboard on the machine to put in the g codes but it has the small tape storage system and you cant do much with that,so i want to run it from a laptop via rs 232 port.so i would welcom any help with this.
ps hope you are reading this rob.
Rob.Wilson:
You have no chance of getting the software Peter , SO you may as well give it to me :lol: :lol: :lol: :lol:
Rob
doubleboost:
Hi
Peter
Rob already has one
I think you should give it to me :lol: :lol: :lol: :lol: :lol:
John
John Stevenson:
Although it's closed down it does say existing customers can be supported by email.
Have you tried emailing them ?
jb3cx:
Hi John,sent them an email last night ,got nothing back yet,
Navigation
[0] Message Index
[#] Next page
Go to full version