Gallery, Projects and General > Neat Stuff

Cutting gears on a shaper.

<< < (4/4)

Noitoen:
I remember when I was younger, the next door factory had scaled up versions of that machine cutting big chain sprockets all day long.

Meldonmech:
Hi
             A robust dividing head can be set up on the shaper to replace the vice, and a single point cutter ground to the shape of the tooth form. A fine lubricated feed and slow machine speed will be required. Always use trial cuts on a test piece unless you  are very experienced.
                                                Good Luck   David

vtsteam:
Very impressive all around!

Navigation

[0] Message Index

[*] Previous page