| Gallery, Projects and General > Neat Stuff |
| Cutting gears on a shaper. |
| << < (4/4) |
| Noitoen:
I remember when I was younger, the next door factory had scaled up versions of that machine cutting big chain sprockets all day long. |
| Meldonmech:
Hi A robust dividing head can be set up on the shaper to replace the vice, and a single point cutter ground to the shape of the tooth form. A fine lubricated feed and slow machine speed will be required. Always use trial cuts on a test piece unless you are very experienced. Good Luck David |
| vtsteam:
Very impressive all around! |
| Navigation |
| Message Index |
| Previous page |