Gallery, Projects and General > Gallery
Gonna Do's.........
Henning:
I am going to borrow shamelessly steal the thumbscrew idea!
I also have an idea about a hinge, but that may hinder placement later on, so jury still out.
DavidA:
A couple more pictures of the same late.
My hi-tech answer to cross slide DRO. It works surprisingly well.
Can you see what the problem is here? And I don't mean all the clutter.
Dave.
Stilldrillin:
--- Quote from: Henning on January 02, 2013, 10:40:43 AM ---I am going to borrow shamelessly steal the thumbscrew idea!
--- End quote ---
You're welcome Henning! :thumbup:
I post up my ideas. To give others, their ideas........ :)
Dave.
Wish I'd thought of a Rawlbolt, for my depth stop......... :Doh:
David.
andyf:
Henning, I used hinges on my gear cover as shown here:
The letters refer to some accompanying text on my website, but I sawed up a cheap door hinge and attached the results at E and E, with the other parts attached to the lathe. The hinges are lift-off, and the pin in the lower one is longer than in the upper one, to help me to replace the cover if I have removed it completely. A toggle clip (like the ones on some toolboxes) at F fastens on to a lug on top of the headstock, to hold the cover closed.
:D It seems I can embed pictures direct from my website without the bother of PhotoBucket. :D
I didn't know that until I tried it.
Andy
mastermaker:
--- Quote from: Henning on January 02, 2013, 10:40:43 AM ---I am going to borrow shamelessly steal the thumbscrew idea!
I also have an idea about a hinge, but that may hinder placement later on, so jury still out.
--- End quote ---
And another Norwegian will swipe the rawl bolt spindle crank idea from DavidA, I've been looking for a simple way of doing this. :clap:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version