Gallery, Projects and General > Gallery
Gonna Do's.........
stirling lad:
:clap: :clap:
very clever David,
I'd love to visit your local flea market :drool:
My local one is only good for fleas :(
...Mike...
Meldonmech:
Hi David
A cool idea and can be made in various sizes, can't beat hand feel when power tapping.
David
Stilldrillin:
Mike, David. Thanks!
I've now used it for the first time. Very easily managed M6 in mild steel, tapping this next little job.
I have a 6" bench grinder. The wheels are too hard, don't cut. And when they do, there's grit over the very limited bench space, and car........
So, when I really need a grinding session, I set up in the middle of the back lawn. So there's no rusty patch left behind on me driveway.
I have been using a 50mm dia diamond disc in the lathe chuck, for the past few years for tool/ drill sharpening. It does the job admirably!
Occasionally though, a little more roughing power is needed..........
I bought a couple of sets of angle grinder disc nuts, and mounted them on stub arbours.........
Didn't bother with the M14 thread, just a slide on fit, and an M6 screw and heavy washer.......
Slips into the chuck........
Diamond rougher disc.......
Not quite so rough, diamond disc........
Old faithful, finisher..........
Works for me! :thumbup:
David D
Stilldrillin:
And, finally.
A 110mm disc of mdf, backing an al oxide polishing disc.......
Good for woodworking. :thumbup:
Had around 180 hits, since I posted this last gonna do, and no comments....... Guess it's run it's course.
I'll see if I can't get the Maiwald project finished, and out of the way.
David D
AussieJimG:
Sorry David, I should have posted my thanks for a good idea. I am an avid follower of all your stuff; just don't say much. But I will try to do better in future.
Jim
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version