Gallery, Projects and General > Project Logs

Making a Cutter Holding Block

<< < (4/8) > >>

sbwhart:
Nice job Bernd  :thumbup:

Now I see what your up to,

Followed that link to HMEN  saw the posher more serious side of Bernd  ::)

Prefer the  :mmr: side

Cheers

Stew

Stilldrillin:
Angled topslide, Bernd? Nice one!   :thumbup:

I`ve only just got the hang of only taking off half of what is required at each pass.....
It takes far more passes than usual, but unable to go oversize. (Usually).  ::)

David.

Baldrocker:

--- Quote ---but it will all become clear in time
--- End quote ---
sbwhart
Cant thick of anything more useless than
clear markout dye  ::)
BR

Stilldrillin:

--- Quote from: Baldrocker on February 19, 2009, 06:03:04 AM ---
--- Quote ---but it will all become clear in time
--- End quote ---
sbwhart
Cant thick of anything more useless than
clear markout dye  ::)
BR
--- End quote ---

 :lol: :lol: :lol: :lol: :lol: :lol:

I`ve not commented on the marking out colour........ It`s all been said before I`ve even thought of it........ ::)

BUT, after more than 50 years of using marking blue, engineers blue, always blue......
The thought of clear marking blue is hilarious.......  :clap: :clap:

David.

Bernd:
Ralph,

I've started to notice the more I write stuff the more little tricks I show that have never been seen or read about.

So, it looks like a small write up about the calibers and the us of a samll angle setting on the top slide to get a finer cut on the lathe is in order. I'll do that right after I finish this project.

Give me a  :poke: if nothing seems to be happening in that direction. :thumbup: after some time has passed of course.  :)

Bernd

Navigation

[0] Message Index

[#] Next page

[*] Previous page