The Shop > Tools

Home-brew 120mm rotary table

<< < (10/10)

shipto:

--- Quote from: arnoldb on August 12, 2012, 03:54:32 PM ---
 I removed the 4-jaw from the lathe with the table-in-making still mounted on it, and set it aside. The 3-jaw went on, and I started on the main shaft. First off, cut a bit off the big bolt from the first photo in this thread:
 

--- End quote ---
I really like the clamp extension plates on the saw  :thumbup: I might nick that idea and never seen it before I usually put a bit the same size in the back of the clamp.
 
 

Navigation

[0] Message Index

[*] Previous page