Gallery, Projects and General > Neat Stuff

Propane furnace and induction furnace

(1/2) > >>

ironman:
Here are two videos I made of a friends furnaces and casting methods.....













(Hope this is ok, Ironman..... David).

tumutbound:
Any more info on the homemade induction furnace? 

[Could you embed your Youtube links in your posts rather than putting in a link to them? ]

ironman:
I did not build the induction furnace so I do not have any infomation on it. If you take the cover of a computor power supply it works in the same way as the  induction furnace works, they can be very complex. I had a go at embedding the videos but It did not work. I'm not very good with computors so I will stick with what I know that works

Stilldrillin:

--- Quote from: ironman on July 17, 2012, 08:35:16 PM ---I did not build the induction furnace so I do not have any infomation on it. If you take the cover of a computor power supply it works in the same way as the  induction furnace works, they can be very complex. I had a go at embedding the videos but It did not work. I'm not very good with computors so I will stick with what I know that works

--- End quote ---

Ironman,
Don't worry about embedding........ Do yer best, until you get it!  :med:

One of the Mods will tidy up, if necessary.  :thumbup:

David D

kd0afk:
What is the cost of using an induction furnace like this to melt iron or steel? I would like to be able to cast my own parts and this seems the way to go.

Navigation

[0] Message Index

[#] Next page