The Shop > Tools
Harrison L5 rescue
Biggles:
thanks Jonny, i will lookout for them, i think the fibre gear was just their for the noise, otherwise they would have made them in different sizes to fit the translation gear changes. :thumbup:
vintageandclassicrepairs:
Hi All,
I just spotted some 14DP gears on Ebay (rusty but cheap???)
http://stores.ebay.co.uk/The-Plane-Iron-Shop?_dmd=2&_nkw=14DP
HTH
John
awemawson:
That ad. is Tim & Digger at G&M Tools in Ashington (West Sussex) - dealt with them for decades !
Biggles:
awemawson, vintageandclassicrepairs, i live between Epsom and Kingston. ref; the gears advertised by G&M. i have had a few for spares but they did not have the specific ones i am after. 40, 63, and 127. These are required for metric threads. I am in the process of stripping the lathe down and repairing it along the lines of mick of this thread. Therefore I will start a new thread when I have got a few days behind me and found out what needs to be done. One thing is for sure; screws and nuts are hacked and need replacing, assuming I can get them off. :nrocks:
tom osselton:
Maybe message Doubleboost he had the 127 division dividing plate made up.
Navigation
[0] Message Index
[*] Previous page
Go to full version