New MIG Welder

[doubleboost]

     

John

[dawesy]

Looks like a nice substantial unit there john. Wire feed looks decent too, usually the biggest problem with the smaller hobby units.
Looking forward to seeing it in use.

[doubleboost]

     

[Pete W.]

Hi there, John,

I can't read Reply #2 - is it that misplaced square bracket again? 

[dawesy]

Very nice john. Been there and dropped a spool before and had the end slip out my fingers. Your right 'bŁ&@cks is the right word

[krv3000]

well dun john do you want a flow meter for it

[doubleboost]

Hi
Bob
Just put the flow meter on that you gave me 
John

[doubleboost]

[S. Heslop]

Got a good laugh at the end of this one.

[John Rudd]

John just never ceases to amaze me..... :

But his sense of humour is just inimitable   

[doubleboost]

[krv3000]

well dun you will be making a bote for that engine to go in next

[micktoon]

Hi John , I cant wait to see this baby get cranked right up  its getting nice welds in that latest vid on the half setting I bet it will melt in lovely on full power  , my 165 amp Murex is not as good at thicker stuff as this welder was on this vid. I cant complain as its been faultless for a good 20 odd years and just does the job with no hitches in general.
  Cheers Mick.

[doubleboost]