The Shop > Our Shop

Project "YOU Bit It Off, YOU chew it", aka installing a Bridgeport CNC

<< < (5/15) > >>

Rob.Wilson:
 :clap: :clap: :clap: :clap: :clap: Nice one Ade  :thumbup:

Have you loaded any G code into it ? ,,,,,,,,,,,, can you manually input a line of code  :scratch:


Rob

Stilldrillin:
That's great news Ade!  :thumbup:

Blummin, WELL DONE!!  :clap: :clap:

David D

AdeV:
Hi Rob,

I don't have it interfaced to a computer yet - that's a (near) future task.

Cheers David :)

Too knackered to go on experimenting tonight (I was up @ 5am this morning doing race car jobs), if someone can give me a simple "here's how you test the spindle works" programming example, assuming I'm a complete dumbo, on a TNC150, then please let me know...

Thanks!

Stilldrillin:

--- Quote from: AdeV on June 09, 2012, 04:31:53 PM ---Hi Rob,

I don't have it interfaced to a computer yet - that's a (near) future task.

Cheers David :)

Too knackered to go on experimenting tonight (I was up @ 5am this morning doing race car jobs), if someone can give me a simple "here's how you test the spindle works" programming example, assuming I'm a complete dumbo, on a TNC150, then please let me know...

Thanks!

--- End quote ---

If I remember rightly Ade.

G20 G40 G80 G90
G24 X0 Y0  ZO
GOO XO YO M03 S500

Or summat similar...... It's been a very long time!

Hope it works. Or, gives everyone a good laugh.......  :thumbup:

David D

awemawson:
IIRC it needs the compressed air conected to take the brake off the spindle

Navigation

[0] Message Index

[#] Next page

[*] Previous page