| The Shop > Our Shop |
| Project "YOU Bit It Off, YOU chew it", aka installing a Bridgeport CNC |
| << < (5/15) > >> |
| Rob.Wilson:
:clap: :clap: :clap: :clap: :clap: Nice one Ade :thumbup: Have you loaded any G code into it ? ,,,,,,,,,,,, can you manually input a line of code :scratch: Rob |
| Stilldrillin:
That's great news Ade! :thumbup: Blummin, WELL DONE!! :clap: :clap: David D |
| AdeV:
Hi Rob, I don't have it interfaced to a computer yet - that's a (near) future task. Cheers David :) Too knackered to go on experimenting tonight (I was up @ 5am this morning doing race car jobs), if someone can give me a simple "here's how you test the spindle works" programming example, assuming I'm a complete dumbo, on a TNC150, then please let me know... Thanks! |
| Stilldrillin:
--- Quote from: AdeV on June 09, 2012, 04:31:53 PM ---Hi Rob, I don't have it interfaced to a computer yet - that's a (near) future task. Cheers David :) Too knackered to go on experimenting tonight (I was up @ 5am this morning doing race car jobs), if someone can give me a simple "here's how you test the spindle works" programming example, assuming I'm a complete dumbo, on a TNC150, then please let me know... Thanks! --- End quote --- If I remember rightly Ade. G20 G40 G80 G90 G24 X0 Y0 ZO GOO XO YO M03 S500 Or summat similar...... It's been a very long time! Hope it works. Or, gives everyone a good laugh....... :thumbup: David D |
| awemawson:
IIRC it needs the compressed air conected to take the brake off the spindle |
| Navigation |
| Message Index |
| Next page |
| Previous page |