The Craftmans Shop > Model Engineering

Looking for V2 Magnum plans by Steven Pierce

(1/1)

V 45:
I found this engine while doing some surfing..actually found an email but came back undeliverable. I would like to try and make this...Steven Pierce's  60° V-twin motorcycle engine. This engine is run on CO2. The scale is about 1/16 and it is made from brass and aluminum. It has a 1/4" bore and 1/4" stroke and is called the "Maxum Magnum."


http://www.floridaame.org/GalleryPages/g1Non0134.htm


Thanx again... V45

V 45:
After looking around somemore ... it was brought to my attention that it's based offf this engine build by David Kerzel.

http://www.john-tom.com/MyPlans/SteamPlans3/DavidKerzelCO2/TwinKerzelCo2.pdf

But I still don't see how he mounted the top of the engine in the Magnum version? Any suggestions ?
Thanx again...V 45

Brass_Machine:
Are you talking about the "valve covers"?

It might be possible the are screw on. I just saw a radial build (gas) where the designer did that.

HMEM Link

Hope that helps?

I have DL'd the Dave Kerzel plans awhile ago and it is on the list!

Eric

V 45:
Hi Eric,
  Yesthanx...I was referring to the rocker boxes/ valve covers. How would you thread that small internal...I'm a new to this just since Jan 12 !!
Thanx again... V 45

Brass_Machine:
I would use a tap. start with a tapered then go to a bottoming tap.

Navigation

[0] Message Index