| The Shop > Our Shop |
| shop |
| << < (3/5) > >> |
| Pete49:
Nice work on the conversion it will be a joy to work in there. Don't forget lots of shelves :clap:. I should look at insulating mine (1/3rd of 3 car garage) as it gets a bit warm in summer (45c+) and cold in winter (average 18c days) though I have a wood stove going most days a lot of heat is lost through the corrugated iron walls. Oh well another job on the list. Pete |
| David Jupp:
If sharing an RCD with the main house, you won't be popular if any of your toys are prone to causing trips. I have a separate Board/RCD for the garage (fitted before house was upgraded to RCD) - I find that the VFD for my Mill/Drill, and sometimes even my workshop PC will trip the garage RCD at switch on. My garage RCD is just a standard domestic variety, I believe there are alternative ones which are designed to tolerate the likes of VFDs. I'm sure your Electrican son will be able to advise if this is anything needing attention. |
| ChriX:
This is looking great. I am looking forward to seeing the machines go in! |
| mechman48:
Well, have progressed nicely with my conversion; new toys arrived..finally :ddb: , had some bother over the lathe but that's another story (a long one!) a few tel.calls to Warco along with a very strongly worded e-mail :wack: , resolved the issue (Warco's don't seem to like answering e-mails?) anyhow to cut a long story short all has been resolved with a very apologetic Warco finally getting things sorted. WM16 Mill & WMV-F 250 lathe, both variable speed: |
| Rob.Wilson:
Hi George :clap: :clap: :clap: :clap: Looks like your well on your way to getting your shop up and running , nice spanking new machines :drool: :headbang: Rob PS any chance you could re-size your photos , just a tad large :thumbup: |
| Navigation |
| Message Index |
| Next page |
| Previous page |