Gallery, Projects and General > The Design Shop
3d indicator design
andyf:
Hi Bill,
What advantages do you see for this 3D design over your earlier co-ax indicator?
No criticism implied - just curious, that's all.
Andy
BillTodd:
--- Quote ---What advantages do you see for this 3D design over your earlier co-ax indicator?
--- End quote ---
It does a different job.
This is an edge finder, allowing any face in X, Y or Z planes to be located easily.
It was inspired by this Haimer device:
andyf:
Thanks, Bill. Now I understand.
Andy
Joules:
Nice drawing and concept, but not sure I can figure out how the probe gimbal works. What keeps it in the centre under a side load. I could understand a ball joint ?
Joules:
Ahhh, the penny dropped, two caged bearing races slide over the sandwiched plate....
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version