| Gallery, Projects and General > The Design Shop |
| 3d indicator design |
| << < (2/16) > >> |
| andyf:
Hi Bill, What advantages do you see for this 3D design over your earlier co-ax indicator? No criticism implied - just curious, that's all. Andy |
| BillTodd:
--- Quote ---What advantages do you see for this 3D design over your earlier co-ax indicator? --- End quote --- It does a different job. This is an edge finder, allowing any face in X, Y or Z planes to be located easily. It was inspired by this Haimer device: |
| andyf:
Thanks, Bill. Now I understand. Andy |
| Joules:
Nice drawing and concept, but not sure I can figure out how the probe gimbal works. What keeps it in the centre under a side load. I could understand a ball joint ? |
| Joules:
Ahhh, the penny dropped, two caged bearing races slide over the sandwiched plate.... |
| Navigation |
| Message Index |
| Next page |
| Previous page |