Gallery, Projects and General > Gallery
CNC'd Loco Wheel & Earning Brownie Points
philf:
--- Quote from: John Stevenson on April 05, 2012, 06:24:08 PM ---Phil,
send me the stl file and what tooling you wnat to use, speeds and feeds and I'll bung it thri Cut 3D and post you the code.
john [ at ] stevenson-engineers.co.uk
--- End quote ---
John,
That's very kind of you. :thumbup:
Email sent.
:beer:
Phil.
John Stevenson:
Phil, Can you resend it please, not showing up here.
philf:
--- Quote from: John Stevenson on April 06, 2012, 04:34:22 AM ---Phil, Can you resend it please, not showing up here.
--- End quote ---
Hi John,
The first file was nearly 20MB - maybe that was why it didn't get to you. I've sent a much smaller one.
Cheers.
Phil.
John Stevenson:
Smaller one wouldn't open.
Found the first file in junk on the server.
This is what Cut3D reckons it's going to do.
Five minutes for the roughing pass and 24 minutes for finishing path but I told it to do a second finishing path at 90 degrees to the first so total of 51 minutes.
Email sent with code.
John S.
philf:
--- Quote from: John Stevenson on April 06, 2012, 05:38:50 AM ---Smaller one wouldn't open.
Found the first file in junk on the server.
This is what Cut3D reckons it's going to do.
Five minutes for the roughing pass and 24 minutes for finishing path but I told it to do a second finishing path at 90 degrees to the first so total of 51 minutes.
Email sent with code.
John S.
--- End quote ---
Thanks very much John, :thumbup:
I'll be down in the cellar shortly trying it out.
Cheers.
Phil.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version