The Shop > Electronics & IC Programing
Real Bull mini-lathe circuit board diagrams.
<< < (2/2)
hopefuldave:
Thanks very much, gents!

The SCR and diode spec's make sense, partiularly the "isolated tab" parts - can't bear to think of what'd happen with the heatsink/bracket shorting the two SCR's....

The mill power feed's a ready-built unit sold for one of the Chinese small mills (OK, it's actually three of 'em rescued from a skip...) - it has a 90V DC motor in it, and a tendency for the control board to burst into flames... Fortunately I have a known-good board to work from! I have to admit I'm a bit worried by the 90V motor being fed from the 240V mains, strikes me that could be why the controllers aren't too reliable...

Dave H. (the other one)
Navigation
Message Index
Previous page

Go to full version