Gallery, Projects and General > The Design Shop

Rolling Mill

<< < (2/4) > >>

David Jupp:
You can get the rolls from these people
http://www.sheffieldforgemasters.com/engineering/home
See the back-up roll in the image on the linked page.
They can also provide castings to your design for the housings for the roll stacks.

You might need a slight extension to the workshop to fit this stuff in though!

sbwhart:
Ok a little bit of explination is required I'm thinking of building a model of a rolling mill using a twin cylinder horizontal engine to power it:-  it won't have any practical work shop use.

Stew

andyf:
This mill is probably a bit too modern:


Here's another, found by searching on YouTube for "Steel rolling mill Sheffield"


Andy

sbwhart:
Thanks guys some good info their

I've got something to work with.

Don't know when it will kick off though I've got plenty to do at the moment.

Stew

Stilldrillin:

--- Quote from: sbwhart on March 23, 2012, 09:28:01 AM ---Ok a little bit of explination is required I'm thinking of building a model of a rolling mill using a twin cylinder horizontal engine to power it:-  it won't have any practical work shop use.

Stew

--- End quote ---

Aaawww.........

David D

Navigation

[0] Message Index

[#] Next page

[*] Previous page