The Shop > Finishing
Cast iron - how well does it polish?
(1/1)
kwackers:
I'm just finishing some cast iron parts for an engine and as always am trying to get a shine on some of them.
But no matter how much I try though the finish always looks a bit 'grainy'...

Now tbh I'd expect that but some of the pics you see on the interweb show what looks like much more highly polished parts than I can obtain.
So, is this a trick of the light/side effect of the photography or is there a method to get a shine on cast iron that doesn't look slightly grainy?
philf:
Kwackers,

It's simple. Just ask Rob Wilson if you can borrow his camera!

 :lol:

Phil.
mzt:
Kwackers,

much depends on the quality of the C.I. You're using.
The conn rod cap I used for an Elmer's cylinder was of the highest quality, it came out so mirror like I will never manage to take a picture doing justice of it.
Here's the best my camera could gain, maybe it will earn autofocusing skills in time: still, with a bit of effort, You can see the cloth texture on the valve face.





If that's enough, I got that result by putting a sheet of sandpaper (the finest grade I had) on a flat plate (plastic ikea cutting board) and slid the face on it till I
removed all the tool marks. Next, I put another sheet of the same grain, which I had already worn out while polishing aluminium. The 'final touch' came using
printer paper as a support for Dremel polishing compound (anything of that kind would do, I suppose) mixed with thin oil.
It was some time spent into useless elbow work, as both the mirror-like faces won't be visible on the finished engine. The rounded parts could be made so on the lathe,
by wrapping the sandpaper (and then the 'polishing' paper) on a lathe tool blank, but I don't think I ever bothered with them.

Removing that black powder deeply embedded into nails and skin will take days, however frequently You wash Your hands.

Marcello
Navigation
Message Index

Go to full version