Gallery, Projects and General > Project Logs

Set-Over Centre

<< < (10/25) > >>

DaveH:
Wong,

That is very nicely done, good use of the toolmakers clamps- clever idea.  :thumbup: :clap:

Milling is at the best of times a slow process, and you did a good job with your mill :clap: :clap: :clap:

Looking good :thumbup: :thumbup: :thumbup:

 :beer:
DaveH

wongster:
Hi Dave,

Thanks. Really feel good everytime I read your comments despite knowing that I did screw up on some parts. Thanks for the encouragement!

Regards,
Wong

krv3000:
HI wong Very well done

Fergus OMore:
Question! How are you going to cope with the three dimensional effect of Pythagoras when all is said and done.

Euclid only did it in two dimensions, if I recall :coffee: 

Miner:
Norman,
The dude that thought that up was bit behind times. If? I'm reading your referances correctly, A dial indicator across the top till it reads true will straighten out that theroy. Royal did much the same on their no longer built screw adjustable centers with a built in level.

Pete

Navigation

[0] Message Index

[#] Next page

[*] Previous page