Gallery, Projects and General > Gallery

Lamina Flow Finished

(1/3) > >>

foozer:
A Lamina Flow engine I built using an Airpot piston - cylinder. Bore 0.620 +/- stroke 0.750.
Majority of pieces made from same jig used to build the flywheel web. Only have an old AA109 so its just a lot of curves, I like curves.

It runs around 125 to 175 rpm depending on the wick size, something I can just pop on the table, light a match and watch it go round.

Robert

Divided he ad:
Looks a pretty sweet machine to me Robert  :thumbup:

Since I've not see this before, is it in the project logs section? If possible I'd like to see some pic's of the main mountings etc. You can't really see them through the spinning flywheel. That said a still of the flywheel might be nice too?



Anyway, as said... Sweet machine  :clap:




Ralph.

Stilldrillin:
That's lovely Robert!   :thumbup:

Blummin well done.....  :clap: :clap:

(Would be even nicer, with a build log).  :poke:

David D

Brass_Machine:
I have to build one of those. I have an airpot cylinder... just need to get on it.

Very nice looking! How big is the choke on it?

Eric


**edited your post to embed the video

DaveH:
Robert,

Magic :thumbup: :clap:

Well done and very nice. :bow:

 :beer:
DaveH

Navigation

[0] Message Index

[#] Next page