| Gallery, Projects and General > Project Logs |
| First mini lathe project, oscillating steam engine. |
| << < (3/22) > >> |
| Stilldrillin:
Just spotted this post, Ross! Where have I been? :scratch: You're away to a good start. Take your time. Steady as you go....... :thumbup: David D |
| Ross:
Another half a day day spent in the shed today, I managed to face the square bar that will be the cylinder to it's final length, I think I'll file some chamfers on two of the corners once I've bored the holes etc.. Some photos; Finished product: After that, I topped the flywheel using a drive from friction: Finished product, I still need to machine the flywheel indents. Lastly, I faced the base and centre drilled. I haven't yet figured out how I'll top it though! That's all for today, more tommorow. |
| Brass_Machine:
nice work! :ddb: |
| Stilldrillin:
Ross. Nicely done, with the square bar in a three jaw chuck....... :clap: The base. Can't you top it using friction drive? Same as the flywheel...... :thumbup: David D |
| wongster:
Hello Ross, May I know what is the black disc between the flywheel and the chuck jaws in the pics showing the driving by fraction? I've 2 x 12mm thick disc to turn and would like to use the same method you have shown. Regards, Wong |
| Navigation |
| Message Index |
| Next page |
| Previous page |