Gallery, Projects and General > Gallery
Fun with Acrylic
Powder Keg:
I have a few pieces of shaft. About 1.75" dia. or so. I am going to try and make some interesting to look at doodads. I started out just messing around. Our Crock pot needed a new handle for the lid. So I thought I'd make me one. I was reading where you can "Fire polish" acrylic. I turned down my knob then sanded it with 220 grit paper then some 000 steel wool. Then I got out the torch :doh: It started out really good. It doesn't take much. I had it spinning in the lathe and the outside kind of flared up :zap: The surface had kind of bubbled up a little. I kind of liked the way it looked so I carefully set it on fire again so it would be more even. Here is the results.
The Miss' was pretty happy with it so I scored some points there\o/ I still need to get a bolt and mount it.
I'm trying to make a couple special cutters for my next doodad so stay tuned.
~Wes~
Divided he ad:
Aww Wes...... I'm nearly bursting here! The innuendo involved :lol:
That's a very interesting looking piece you have there. I haven't toasted acrylic since I was a kid.... and that was more about the flames than anything else! :bugeye:
I'm looking forward to seeing what you come up with in the doodad cutter dept :borg:
Ralph.
Oh I can't help it.... I'm just so damn childish!
--- Quote ---I turned down my knob then sanded it with 220 grit paper then some 000 steel wool.
--- End quote ---
Bloody hell! :lol: :lol: :lol: :lol:
raynerd:
Wes, they would make some nice bottle stoppers/wine stopper tops!
Chris
Scuba1:
I bet that hurt
DaveH:
Wes,
I say this with tears in my eyes - very nice :lol: :lol: :lol:
:beer:
DaveH
Navigation
[0] Message Index
[#] Next page
Go to full version