| The Shop > Metal Stuff |
| Key steel vs BMS sq bar |
| << < (3/3) |
| DaveH:
John, No - you haven't misread anything, it was just that as an apprentice "2000 years ago" I was told "Use key steel for square and rectangular stock" it is a much better "quality" steel than "bright mild steel". Also I was told it had less of a tendency to warp after machining. It is something that has stuck with me - I forgot everything else. :lol: :lol: :lol: Maybe it was in 1960, I also thought it may have been heat treated but I don't think it is. If it is just from it's shear strength, I would sooner use a free cutting steel. :beer: DaveH |
| Pete.:
If it's an important part that mustn't fail I'd go for proper keystock but if it was just some pulley on a polishing machine shaft etc I would just use whatever I could machine to fit the keyslot. |
| Anzaniste:
Key steel is a medium carbon steel supplied cold drawn and would have a tensile of 35/45 ton/sq in in old money. I always remember the rule of thumb that Mild Steel had a tensile strength of approximately 30/32 tons/sq in. Steel below 0.40% carbon, i.e. mild steel will not harden by quenching. Key steel has 0.50% carbon therefore will harden by quenching although not much. There is a hell of a lot more to it than that but not being that clever I can't remember all I was taught in the olden days!! :palm: |
| Navigation |
| Message Index |
| Previous page |