Gallery, Projects and General > Project Logs
Ball or Radius cutter
MadNick:
Evening,
This afternoon's progress.
My neighbour came up trumps with a brass piano hinge of the ideal width for my shims -
I fitted them to the sides of the toolpost by way of self tapping screws. I originally tried to use an M3 tap with some tiny countersunk crosshead screws but for some reason I just couldnt get the screws started after tapping out the holes - I believe my M3 tap to be just too worn. You have to work with what you have so I used the self tappers and ground them flush -
A quick dressing with some emery paper and wayhey, the shims werent brass at all but brass-coloured. Too late to do anything about it now as those shims are going nowhere.
The next job was to find the centreline on the toolpost -
I milled out a shoulder and then drilled/tapped three M6 grub screws -
Tomorrow is what I believe to be the tricky bit, milling out the recess for the tool. Got to get it right or the whole toolpost becomes scrap...
Nick
Divided he ad:
Nice save Nick :thumbup:
Just a note before you machine... Best to turn a point in the chuck first and re-check that line... I made my first one to the tail stock height as Steve Bedair said (IIRC) It was approx 0.20mm too low. Subsequently leaving a pip on all I machined!
Worth the extra time to check.
Fergus,
I'm aware that much is in books.... Sadly I do not own many of the books out there. Some, but not many. Hence my questions.
Fair comment on the smaller lighter machinery.... I'm a mere 37 and much of it is too damn heavy now!
Ralph.
rleete:
Easiest way for me was to mount it in the lathe, and drill the hole with the chuck. Since I was using a 1/4" round bit, that ensures it is perfectly on center.
MadNick:
Thanks for the responses :)
Last night I came to a simpler conclusion in mounting the cutting tool.
Rather than bolting up the tip in the picture, I could use my 8x8 carbide toolholder, mounting it on the upright part by cutting a slot/drilling a hole and securing with a couple of grub screws.
This would allow me to swap out tips and save a lot of aggravation/time in forming the toolpost.
Hopefully will get a chance to do some more work on this later.
Nick
ksor:
>> MadNick
I think you have to protect your balls - the ones in the bearing of cause - I think small chips will find a way to obstruct a nice smooth turning.
I did one much like yours - http://kelds.weebly.com/kuglevaeligrktoslashj.html - see the 6. 7. 8. picture the balls are hiden behind a skirt - just like a scotchman would do :D
But try it out - if it's a problem - you can turn a ring on the lathe and solde it in place to protect the balls.
You HAVE to use brass to protect against scratches - again look what I did - it was a bit tricky to mill it but it can be done.
You can make Google to translate my website !
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version