| Gallery, Projects and General > Project Logs |
| Potty Simpson and Shipton Short Stroke Engine |
| << < (11/27) > >> |
| doubleboost:
Hi Stew Coming on leaps and bounds :bow: :bow: :bow: Did you get some 2mm studding I could always screw cut you a length :lol: :lol: :lol: :lol: :lol: John |
| sbwhart:
--- Quote from: doubleboost on February 18, 2012, 04:45:03 PM ---Hi Stew Coming on leaps and bounds :bow: :bow: :bow: Did you get some 2mm studding I could always screw cut you a length :lol: :lol: :lol: :lol: :lol: John --- End quote --- Yes I did John a 1M length from flea bay £8 including postage No idea how they managed to screw cut that length :scratch: :lol: :lol: :lol: Stew |
| arnoldb:
Good going Stew :clap: :clap: :clap: :beer:, Arnold |
| sbwhart:
:beer: Arnold Finished off the con rods Drilled and reamed Then turned up the bearings I needed eight of them I didn't want to P*** about to much, so turned a length of bar for a good fit in the con rod ends and parted off. I'm using my independat four jaw that chucks up very true, this allowed me to drill and ream right through the bar. Then it was just a matter of parting the bearings off to length, fitted into the con rod with a spot of bearing retainer. A bit of work with filing buttons to shape the ends and this is they fit to the cylinder Thing comming together well Stew |
| saw:
As usual very nice build Stew :bow: :bow: |
| Navigation |
| Message Index |
| Next page |
| Previous page |