| Gallery, Projects and General > Gallery |
| Gradating tool |
| << < (3/3) |
| Gerhard Olivier:
That is nicely done I assume its is a rack and gear :scratch:(flat gear and a round one????)that does the pushing. Seems a lot more work but then that is half the fun Gerhard |
| old-biker-uk:
--- Quote from: geroli on January 19, 2009, 01:53:57 PM ---...I assume its is a rack and gear ... --- End quote --- Correct - at the time I was into gear-cutting and had just cut a shed load of gears for a geometric chuck so one rack and one more small gear was not a problem. Mark |
| bogstandard:
I use engraving tools very similar to the ones shown here, so I do any graduating on my mill. For straight I use the vice, and for circular graduations, the rotary table. Not as easy to use as a graduating tool because I have to think about engraving distance, but it does me for the small amount I want. http://www.arceurotrade.co.uk/Catalogue/New-Products/Cutting-Tools sgoB |
| Navigation |
| Message Index |
| Previous page |