| Gallery, Projects and General > The Design Shop |
| The better Ball Turner?? |
| << < (2/2) |
| Gerhard Olivier:
Yes inherently centred on the tool post. I cut from the up position down left and right for ball. To make a round shoulder it would be from top down or right (ts end). It it is placed on a hight ajustable tool holder it could be persuaded to do ovals as well. The cutting tool drawn above (rcmt tc insert on top of a round post) would aready be an improvement to what I have made. The boring head is 50mm diameter -but only the tip of the cutter is close to the chuck so this gives a bit more space. |
| Navigation |
| Message Index |
| Previous page |