Gallery, Projects and General > Project Logs
Casting pulley for my Gingery mill project
<< < (3/3)
Doc:
Looks like a nice poor!
I've always wanted to give that a try but have not.
Looks like you have a pretty nice set up.
Gadget:

--- Quote from: buffalow bill on December 06, 2011, 03:58:20 PM ---Gadget,

That’s a nice furnace you have.  :clap: :clap: :clap: Could you post some info on it.

Hope you are doing a log on the build!  :beer: :beer: :beer:

Bill

--- End quote ---

Bill I'm using a Nudge burner. You can find the instructions on it here;  http://www.alloyavenue.com/vb/showthread.php?2895-How-to-Build-a-Nudge-Burner&highlight=burner

No build post on the furnace since it's been evolving for the last 20 years.  I've been posting a build log here on the mill.
Bernd:
That's a pretty neat nozzel build.

Thanks for the link.

Bernd
buffalow bill:

Thanks for the link, getting my shopping list for one.

Have just started a furnace build, the problem was the burner.  Thanks again Gadget.  :headbang:

Bill
Navigation
Message Index
Previous page

Go to full version