The Shop > Our Shop
Material Storage
ksor:
--> Spatkey ... you got me ! :Doh:
AussieJimG:
How many ways are there to retrieve a bit of stuff that is too short?
1. Use a longer bit with superglue on it,
2. Magnet on a piece of string (for steel)
3. Take out all the longer bits and remove by hand,
4. Leave it there and put a note on the tube so it can
be removed when it is REALLY needed
5. ?
ksor:
I should say - it never happened to me yet ! :)
PeterE:
My version of storing very different lengths of rods and bars is a small trolley-like thing as shown below.
The bottom tray has a small drawer unit for small ends, bits and bobs, and behind that just two shelves with large holes at two levels to support the bars at around half-way or so. I never included sides to provide better access when the wrong stuff falls down the holes.
The long rods are around 1 m and the lower support shelf allows rods up to some 40 cm or so.
The whole thing rolls on swivelling wheels and can be pushed aside to be out of the way wherever I will be working (or searching for lost nuts and bolts :doh: ).
BR
/Peter
ksor:
I mode one of them too, not so big - it's standing beside mu STANKO lathe: (4. picture)
http://kelds.weebly.com/mine-maskiner.html
To drive around !
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version