Gallery, Projects and General > How do I??
elmers 25
AcieraF3:
:clap: What do you mean horrible. It is great and very clear. Thanks very much, I will drill the port this weekend hopefully and show you a runner!!?
Teun
winklmj:
To mark where to drill the holes when I did mine, it took a tiny piece of shapened rod and stuffed it into the port in the cylinder wall--so it protruded only a tiny amount. Then bolted it all up and spun the crank a few times so I got a small scribed line. Then I just drilled the holes at the ends of the lines.
jgroom:
I may be seriously confused (usually am :palm: ), but why not just use Elmers drill jig? :scratch:
Jeff
John-Som:
I agree with Jeff. Elmers drill jig has worked just fine for me and in fact it is one of the attractions of this design for the newbie.
John-Som
AcieraF3:
Jeff and John-som, I did use the jig but I thought is was only an aid for drilling the ports in the stand and not in the cylinder. Probably I am confused now :scratch:
teun
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version