Author Topic: Ball Turner Question  (Read 4604 times)

Offline HS93

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 788
  • Country: gb
Ball Turner Question
« on: January 10, 2009, 11:20:06 PM »
Ok be gentle with me , just a question , has anybody made a ball turner using a round insert for a cutting tool, I started using them for genral turning after some advice from the "Bogster"  :bow: and found I had a very smothe finnish without much effort, but I do only use brass ond ally.

Peter
I am usless at metalwork, Oh and cannot spell either . failure

Offline Brass_Machine

  • Administrator
  • Hero Member
  • *****
  • Posts: 5504
  • Country: us
Re: Ball Turner Question
« Reply #1 on: January 11, 2009, 03:48:29 PM »
Peter,

I didn't see this reply when I split the tread. Here is a link Ralph posted for you.

http://madmodder.net/index.php?topic=282.0

Eric
Science is fun.

We're all mad here. I'm mad. You're mad.