The Shop > Electronics & IC Programing

Panel mounted QWERTY keyboard

<< < (2/3) > >>

krv3000:
HI we got the ones used in the university from RS

mattinker:

--- Quote from: andyf on October 16, 2011, 09:36:04 AM ---Rob, would one of these do the trick?
http://www.memorybits.co.uk/shop/keyboards/roll-up-keyboard-(black)-urk100/8275

Andy

--- End quote ---

Now why didn't I think about this when I was looking at the in a shop the other day?

Thanks for putting two and two together!

Regards , Matthew

awemawson:
I used one of those roll up jobs when I converted a Denford lathe to more modern PC cnc control, but I found them rather flakey. Sometimes worked, sometimes didn't. I tried three different ones with vaaying sucess. Good concept though when your hands are oily and there's swarf in the air.

Country Bubba:
I've used one on my mill/drill cnc for over 10 years with no problems :thumbup:

"http://www.memorybits.co.uk/shop/keyboards/roll-up-keyboard-(black)-urk100/8275 "

Rob.Wilson:
Cheers for the input lads ,much appreciated  :headbang:

I have one on order .


Rob

Navigation

[0] Message Index

[#] Next page

[*] Previous page