The Craftmans Shop > General Crafts
Bowling ball engraving vise
Powder Keg:
I decided it's time to build me an engraving vise. This had to be done on the cheep! I looked around my shop and came up with a blue bowling ball and a Harbor freight vise. I spent a good part of my free time today trying to come up with a easy way to cut off a slice of this ball on my bandsaw.
I ended up just strapping it to a board with a ratchet strap.
It worked perfect!!! I cut off what looked like the right amount.
Bolted on a cheep drill press vise I had lying around and presto-chango!!!
I have a fancy engraving vise. I still need to find a bigger doughnut for it to sit on. But I think it will work out great!!!
Thanks for watching,
~Wes~
:wave:
fixerup:
Great re-use project!
That ball will provide a nice pivot point and will be heavy enough for stability. I started looking for a bowling ball :beer:
Phil
PTsideshow:
Here is a simpler version lighter duty if you will
It is one of the Harbor freight swivel vise with the suction or clamp base. I also have an aluminum natural finish one from our US aldi's version.
I just enlarged the one hole to slip press fit the vise shaft.
You can put the inner tube in the tire and adjust the air pressure to make it easier to move the tire.
That is also one of the HF wheel/tire 10" size with the wheel removed.
Pete49:
Mr Powder you never cease to surprise with your cheap and 'out of left field' ideas. :smart: Don't stop as many of us like that method and helps us to think 'outside of the square' as it were. :doh:
Pete
Stilldrillin:
Great thinking Wes! :clap: :clap: :thumbup:
I've never seen such a simple/ sensible/ logical, handworking set up before....... :bow:
David D
Navigation
[0] Message Index
[#] Next page
Go to full version