Home Base > Introductions
New member (engine modeler) from San Francisco
cst4252:
Hi all,
My little oscillating steam engine is almost complete. I need some fasteners and fix some screw-ups I made. It doesn't warrant a build thread, but I have a few pictures I took. The pics demonstrate the well-stocked shop we have at school (De Anza in northern California).
I'm attempting to post pics. The first shows the facing of the vertical brass frame using my favorite took, a Sandvik 2" shell mill. It leaves a beautiful finish on the brass and aluminum.
The second is the bearing insert in a collet chuck before drilling the mounting holes. Everything lined up well using the DRO rather than a rotary table.
The third picture is the semi-finished engine. I'll post a video once I have it running on compressed air.
I'm on to the next one today!
Chapman
AndyB:
Hi Chapman,
Greetings from across the pond.
Looking forward to your posts
Andy
saw:
Not bad at al, looking forward for the vid :thumbup:
jgroom:
Welcome Chapman! Very nice little engine!
Cheers
Jeff
Rob.Wilson:
Hi Chapman :wave:
I hope we get to see your engine builds :poke: :D
Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version