The Craftmans Shop > New from Old
First post
PeterE:
Nice restore and reuse :bow:
I looked at the first picture and it says 1500 (grammes I suppose) which is quite heavy even for a blacksmiths hammer. As you mention, I guess that you are into armours and stuff. Do you drive the steel sheets from the back side agains a soft pad, or from the front side against a hard pad to create the desired dome?
BR
/Peter
Russell Nash:
I have a log.
The log has a hollow in the top. You use different size hollows for different curves. Once I have my desired curve I put it over form and beat it from the other side with a planishing hammer. I've done a bit of this with smaller hammers. I just finished this one, and I'm busy packing my shop right now. It will be December or so before I'll get to try this one out.
PeterE:
OK, so basically like silversmithing only using harder materials and heavier tools.
How often do you need to soften the steel?
BR
/Peter
Russell Nash:
Haven't gotten into steel yet. That's why I made the hammer. :ddb:
I've beaten up some brass and copper. The last time I beat steel was forging back in middle school.
Navigation
[0] Message Index
[*] Previous page
Go to full version