| Gallery, Projects and General > Gallery |
| Dual Purpose Lathe Carriage Stop |
| (1/2) > >> |
| Aestus57:
Hi again folks, Got the bug at the moment and can't keep out of the workshop!! Put together this Lathe carriage stop for my Warco 918. The "dual purpose" bit means I can attach a Dial gauge at the same time, or use without, whatever, anyway I'll let the photos tell the story. :mmr: |
| dickda1:
Nicely done! :thumbup: -Dick |
| DaveH:
Very neat, and useful also :thumbup: :clap: :beer: DaveH |
| Henning:
Nicely done! Is the dial indicator only held on by the magnet? |
| Lew_Merrick_PE:
--- Quote from: Henning on September 07, 2011, 06:24:10 AM ---Is the dial indicator only held on by the magnet? --- End quote --- No, if you look, it is held on by the screw/extended-nut clamp that locks the extending bar. And yes, it is nicely done! |
| Navigation |
| Message Index |
| Next page |