| Gallery, Projects and General > How do I?? |
| 4" chuck on a 4" rotary table |
| << < (4/4) |
| Jonny:
Sorry wheeltapper but guarantee that will move, same with any centre fixing however tight a tolerance, been there done it. I think i know the chuck, its a backing pale jobby. Take the chuck apart, remove the scroll etc and have a look where you can drill straight through. Usually on the side of the register clearing the scroll and jaws. I had to do it with a Vertex four T slotted table, been permanently on 12 years. Can be seen here. |
| Navigation |
| Message Index |
| Previous page |